Description
Dr. Fixit Bitufix is an emulsified thixotropic bitumen protective coating. The coating dries to form a black
flexible protective film. The finished film forms a tough barrier to vapor transmission.
Typical Applications
Dr. Fixit Bitufix is used for providing damp proofing for below ground concrete structures which are above the
water table. The coating is also used as a moisture vapor barrier on block works and concrete surfaces prior to
cladding. This can also be used as the protective coating for built- up roofing systems along with fabric.
Features
- Resists the attack of salts like chlorides and sulphates that are present in the soil.
- Easy to apply
- Cold applied
- Adheres to concrete
- Can be applied in closed or confined spaces
- Water-based
- Non-flammable
- Versatile
- Economical
Packaging
5 & 20 Ltr
Method of Application
The application temperature should be between 5°C to 55°C. Application procedures may vary slightly
depending upon site conditions. The general recommended guidelines for the application of the bitumen
coating is as follows:
1 . SURFACE PREPARATION
The surface shall be cleaned thoroughly of all contaminants like dust, traces of curing compound, oil and
grease.
All surface imperfections and protrusions are to be removed and repaired. Structurally unsound and friable
concrete must be removed and repaired with a suitable repair mortar or PMM.
2. PRIMING
Primer is always recommended prior to coating as it not only penetrates into the concrete pores and seals
the substrate. It also acts as an adhesion promoter for further coatings. The primer coat can be made in the
site by diluting the same bitumen emulsion with 20% water. The primer may be applied by a brush, roller
or airless spray. Allow the primer to dry before any further coats are applied. However, if the primer after
application is left open for more than 24 hours after it becomes dry, clean the surface of any settled dust and
apply a fresh coat of the primer.
3. APPLICATION
Stir the contents of the drum thoroughly prior to application to remove any sediment. The application can be
done with a roller, brush or airless spray. Apply the coating at a coverage rate of 1-4 m2/Ltr/ coat, depending
on the dry film thickness required. 2nd coat to be applied in a direction perpendicular to the 1st coat.
Brand TDS - https://drive.google.com/file/d/16kuAEZk-57oEWQTmGQ6tcnWgN_qgKc7d/view?usp=drive_link
Reviews
There are no reviews yet.